Sensitivity improvement of aluminum-based far-ultraviolet nearly guided-wave surface plasmon resonance sensor

An aluminum (Al) based nearly guided-wave surface plasmon resonance (NGWSPR) sensor is investigated in the far-ultraviolet (FUV) region. By simultaneously optimizing the thickness of Al and dielectric films, the sensitivity of the optimized Al-based FUV-NGWSPR sensor increases from 183°/RIU to 309°/RIU, and its figure of merit rises from 26.47 RIU^-1 to 32.59 RIU^-1 when the refractive index of dielectric increases from 2 to 5. Compared with a traditional FUV-SPR sensor without dielectric, the optimized FUV-NGWSPR sensor can realize simultaneous improvement of sensitivity and figure of merit. In addition, the FUV-NGWSPR sensor with realistic materials (diamond, Ta₂O₅, and GaN) is also investigated, and 137.84%, 52.70%, and 41.89% sensitivity improvements are achieved respectively. This work proposes a method for performance improvement of FUV-SPR sensors by exciting nearly guided-wave, and could be helpful for the high-performance SPR sensor in the short-wavelength region.     

光寻址电位传感器的正交相位检波检测方法

光寻址电位传感器的幅度检测方法易受噪声干扰,灵敏度差,信噪比和精度低,且受调制光源的影响较大,影响检测结果的准确性.为此提出了一种基于正交相位检波的光寻址电位传感器检测方法.该方法是将光寻址电位传感器的输出光电流信号分别与两路正交信号相乘,通过低通滤波提取直流分量并相除,即可得到光寻址电位传感器的输出信号相位信息.与已有的光寻址电位传感器相位检测方法相比,该方法具有算法复杂度低、实时性高的优点.实验研究了调制光源光强对光寻址电位传感器幅度检测和相位检测的影响,对比分析了光寻址电位传感器的传统幅度检测方法与正交相位检波检测方法对pH检测的灵敏度、线性度及信噪比.结果表明,相比于幅度检测方法,调制光源光强对光寻址电位传感器的相位检测影响更小,在频率为10 kHz,pH的范围为1.68~10.01的情况下,相位检测方法比幅度检测方法测得的灵敏度增加了7 mV/pH,精度提高了14.9 mpH,非线性误差减小了0.003%,均方差减少了0.1051×10^-5,信噪比增加了8.2827 dB.该方法特别适用于弱光下的光寻址电位传感器检测.     

航空导管弯曲试验的疲劳裂纹萌生寿命

飞行器液压导管受接头和卡箍等约束，在使用的振动环境中，会因弯曲应力而导致破裂，影响到飞行安全．本文对飞行器液压系统通用的不锈钢导管的裂纹萌生寿命进行了试验研究．首先在对8 mm、12 mm 无缺陷导管和含U 型缺口8 mm 导管的疲劳试验和有限元分析的基础上，得到了导管的最大拉应变-裂纹萌生寿命数据．然后采用基于强度极限和弹性模量估算法的Manson-Coffin 公式来预测导管裂纹萌生寿命．最后引入加载类型修正系数、表面质量修正系数、试样尺寸修正系数、应力集中敏感系数和有效应力集中系数，使修正后的公式对三种类型的导管均有较好的裂纹萌生寿命预测精度．     

固体力学有限元体系的结构拓扑变化理论

本文是文[1]的继续.文[1]提出了杆件系统的结构拓扑变化理论和拓扑变化法本文将这一理论和方法推进到连续体有限元体系;且在此基础上揭示出有限元体系的一个新性质,称为基本位移之梯度的正交性定理,从而给出一套设计敏度的显式表达式,可直接用于计算.     

一类含参广义集值拟变分包含组的解的灵敏性分析

本文引入了一类新的含参广义集值拟变分包含组,应用隐预解算子技巧,建立了该类变分包含组与一类不动点问题的等价性,在适当的条件下,分析了含参广义集值拟变分包含组的解的灵敏性,所得结果推广改进了最新文献中的许多结果．     

Maximizing a Linear Fractional Function on a Pareto Efficient Frontier

We consider the problem of maximizing a linear fractional function on the Pareto efficient frontier of two other linear fractional functions. We present a finite pivoting-type algorithm that solves the maximization problem while computing simultaneously the efficient frontier. Application to multistage efficiency analysis is discussed. An example demonstrating the computational procedure is included.     

基于M-Z干涉仪原理的光纤超声检测

提出了一种基于M_Z(Mach_Zehnder)干涉仪原理的光纤超声检测技术和U形结构的光纤传感器。讨论了光纤传感器与超声波之间的相互作用关系。对传感器的灵敏度与传感光纤的有效长度、U形结构的个数之间的关系进行了理论分析,实验结果和理论分析结果是一致的。通过比较超声波在三种不同入射方式下探测器的输出电压可知,该结构的光纤传感器在声信号垂直入射时由探测器探测到的信号最强,即传感器有很强的方向性,适合于对声表面波的定向检测。     

关于惠斯登电桥测电阻倍率与检流计灵敏度关系的研究

在相同的设备条件下，电桥临近平衡时灵敏度最高的最佳倍率是：组成倍率的两个电阻的数量级与待测电阻数量级相等，且比值为1的倍率。     

Mathematical Modeling, Control, Computer Simulation and Laboratory Experiments of a Spatial Servopneumatic Parallel Robot

In this paper, the special construction of a parallel robot, called spatial servopneumatic multi-axis test facility, will be discussed. The investigations include the following aspects: (i) the laboratory set-up of the robot, (ii) various results obtained in laboratory experiments, taking into account quite different control algorithms and command-input signals, (iii) a comparison of the laboratory experiments with the computer simulations of Part I of this paper, and ({vi}) a quality check of the results compared with the cost of the different controller realizations. The results of both the computer simulations and the laboratory experiments show: (i) The dynamic behavior of the parallel structure can be tremendously improved by using sophisticated nonlinear control algorithms. (ii) This improvement has to be paid by a drastically increased amount of work for deriving the model equations and control algorithms, and by augmented hardware cost of the sensing elements and controller electronics. (iii) Carefully developed model equations and identified model parameters provide theoretical models of the complex parallel structure that are very close to reality. This enables the design engineer to systematically investigate constructive alternatives of the design parameters, sensor and actuator concepts, and control strategies of the MAP prior to their hardware realization.This work has been supported by the German Science Foundation (DFG) under Contract No. Ha 1666/6-3.     

线性规划联合算法的理论与应用

本在[1]的基础上．较系统的叙述了线性规划联合算法的步骤、相关理论及其应用，指出该算法具有避免人工变量、减少迭代次数、使用灵活、应用方便等特点。